Firstly this output is used to clear the device's internal memory ("general reset"). The output can also be used as a signal output for a higher level controller. It signals that the base unit is in a RUN state.
Small controllers
Configurable safety systems PNOZmulti
What is the function of the output OA0 on the base units PNOZmulti (PNOZ m1p, PNOZ m2p, PNOZ m3p, serial and ETH)?
Headoffice
Pilz GmbH & Co. KG
Felix-Wankel-Straße 2
73760 Ostfildern
Germany
Telephone: +49 711 3409-0
E-Mail: pilz.gmbh@pilz.de
Technical Support
Telephone: +49 711 3409 444
E-Mail: support@pilz.com
Americas
- Mexico: +52 55 5572 1300
- United States (toll-free): +1 877-PILZUSA (745-9872)
- Canada: +1 888-315-PILZ (315-7459)
- Brazil: + 55 11 4942-7032
Europe
- United Kingdom: +44 1536 462203
- Germany: +49 711 3409 444
- Finland: +358 10 3224030 / +45 74436332
- Portugal: +351 229 407 594
- France (toll-free): +33 3 88104000
- Sweden: +46 300 13990 / +45 74436332
- Italy: +39 0362 1826711
- Ireland: +353 21 4804983
- Belgium: +32 9 321 75 70
- Denmark: +45 74436332
- Switzerland: +41 62 889 79 32
- Netherlands: +31 347 320477
- Turkey: +90 216 5775552
- Spain: +34 938497433
- Russia: +7 495 6654993
- Austria: +43 1 7986263-444
Asia Pacific
- Japan: +81 45 471 2281
- Taiwan: +886 2 25700068
- New Zealand: +64 9 6345350
- South Korea: +82 31 778 3390
- Singapore: +65 6829 2920
- Australia (toll-free): +61 3 9560 0621 / 1300 723 334
- Thailand: +66 210 54613
- China: +86 400-088-3566
Was this article helpful?