Firstly this output is used to clear the device's internal memory ("general reset"). The output can also be used as a signal output for a higher level controller. It signals that the base unit is in a RUN state.
Small controllers
Configurable safety systems PNOZmulti
What is the function of the output OA0 on the base units PNOZmulti (PNOZ m1p, PNOZ m2p, PNOZ m3p, serial and ETH)?
Contact
Pilz Czech s.r.o.
Zelený pruh 95/97
140 00 Praha 4
Czech Republic
Telephone: +420 222 135353
E-Mail: info@pilz.cz
Technical Support (office hours)
Telephone: +420 222 135354
E-Mail: Support@pilz.cz
Was this article helpful?